Heating of injected plastic parts. Technical data : Volume: 8000 l Maximum temperature: 85 ° C Usable volume : width: 2200 x depth: 2200 x height: 2150 mm Power : 22000 W by shielded stainless steel heating elements - construction in modular sandwich panels - stainless steel interior side panels - White painted steel exterior side panels - 3 mm thick stainless steel oven floor with chamfer at the front, so that it is not limited in terms of load and to have easy access with a trolley or pallet truck - insulation by 100 mm of injected polyurethane foam - access by a double swing door - closing by central lever 2 points and interior release handle

- 1 extractor 1000m3 / h under 500Pa (estimated final flow ~ 800 m3 / h without connection, oriented outlet upwards, connection Ø160 mm) - 1 galvanized steel filtration box - 1 F7 prefilter - 1 H14 filter - 1 pressure switch for monitoring fouling (fault indicator on the control panel) - air renewal with motorized valve and controlled by the cold outlet of the controller. Regulates at low temperature.